OPTO ELECTRONICS
OPTO -  MECHANICAL PRODUCTS
Company Products support demo lab contact us enquiry
 
Overview
Vibration Isolation System
Tables with Rigid Stands
Breadboards
Solid Aluminum Breadboard
Enclosures
Honeycomb Table with Supporting Stand
Vertical Optical Honeycomb Table
L-shaped Optical Honeycomb Table
 
 
   
 
Optical Tables > Overview
  Next >>
 
AN ADVANCED SANDWICH CONCEPT OF HONEYCOMB HEXAGONAL CELLULAR CORE
 
Our cellular core is mainly made of Aluminum Alloy (Foils) with the expansion method:
 
Aluminum foil (in rolled form) is fed into high precision machine where continuous printing of adhesives is applied. Foils are cut, stacked in layers, cured and slices are sawed from the stacked to from the required thickness. The slices are then expanded to form Honeycomb Breadboards to required Length, Width and thickness.
 
 
 
The Process is as follows:
 
Aluminum foil grinding
Cleaning of the foil.
Foil is then dipped in hot water bath
Chopping
Slab Curing.
Band Saw cutting.
Top and Bottom milling
Core is then formed after expansion for the required length.
Aluminum core is finally bonded (high temperature bonding) between the two sheets to get the breadboard.
 
 
 
 
LESS – NOISE AIR COMPRESSOR:-
 
Oil free less noise Air Compressor.
Noise Level: - 70db at 1 meter distance.
Continuously rated with built in rugged motor, ¾ HP 230 V single Phase.
Piston Type, Permanent lubricated ball bearings.
Max. Pressure:100 PSIG (8.5 kg/cm3)
Free Air Displacement : 100 Liters / Min (4.3C fm)
Tank Capacity : 20 Liters
Total weight of the Compressor: 15 Kgs.
Portable Die cast Aluminum components used to keep the overall weight low.
 
 
 
TEN GOOD REASONS FOR CHOOSING “OPTO” TABLES
 
Expertise through experience – established 1976.
Wide customer base.
Over 500 installations of honey comb tables across the country.
Table Top is made of Stainless Steel sheet, 6mm thick – S.S.-304 and bottom is Aluminum sheet – 3mm thick.
Cellular Core is made of Aluminum foil, 0.25mm thick, which assures years of service without any corrosion problems especially if the tables are supplied to coastal areas.
The cellular core, top and bottom sheets are rigidly and permanently bonded with especially formulated high strength epoxy
Side – Walls are made of Aluminum, 2mm thick for high structural rigidity.
Top surface is sanded with an orbital pattern to remove burrs and provide non-reflecting finish
Good flatness ranging 0.1mm to 0.3mm over 1 meter square area.
Standard hole pattern: - M6 on 25mm centers.
 
© 2010 Opto Electronics (P) Limited   All rights reserved. Positioning people since 1976